Hygger Wave Maker Pump

Product Features

• Customized flow

The built-in controller of the intelligent aquarium wave maker can set various flow modes, power, and frequency according to sunrise, sunset, day, and night to simulate waves.

• Smart LED controller

With the LED display controller, you can set the intensity and flow mode of the wave, and you can also set the automatic off mode for 10 minutes for feeding.

• Quiet operation

The safe 24-volt DC-controlled wave generator has energy-saving magnetic thrusters and motors to quietly circulate water, improve water quality, and eliminate dead spots.

• Magnetic mounting

You can install it anywhere using a strong magnet suction cup. In addition, you can easily install, adjust and remove.

Directions for Use

Follow the steps below to install the wave maker pump:

Step 1: Place the power head 15-20 cm below the waters surface.
Step 2: Make sure the wave maker is fully submerged in water.
Step 3: Connect the power head to the controller with a DC adapter.
Step 4: Plug in and use.

Maintenance tips:
1. Clean the power head regularly to extend its service life.
2. The controller and adapter are not waterproof; please keep them dry.
3. The power head must be completely submerged. Do not run in dry conditions!
4. Suitable for indoor use only!

Other useful tips:
1. If you set wave mode into 4 (random mode), power and frequency cant be adjusted, such as 1040, 2040, 3040, 4040, and 5040.
2. If you set wave mode into 3 (constant stream), frequency cant be adjusted, such as 5138, 5238, 5338, and 5438.
3. Something is clogged inside if the power head runs in reverse. The impeller needs to be removed and cleaned.
4. Error code 7 indicates that the impeller is stuck. You need to unplug the power and take it out, let the motor fan turn a few times, and then restart it.
5. Remember to place the pump 6 inches below the water surface. Too shallow water will also result in error code 7.